Random good picture Not show

1. The cylinder head has been carefully machined to increase air-flow.

2. The engine block and alloy cylinder head is shared with the 1.4-litre Energy engine so the bore is identical.

3. The cylinder head is heavily finned for strength.

4. Place the engine cylinder head over the dowels.

5. The cylinder head gasket is made of solid steel.

6. Clean the exhaust manifold and cylinder head mating surfaces.

7. This is achieved by using cylinder head gasket.

8. Remove control cables from cylinder head cover clip.

9. The powder cylinder head good case of impurities. 3.

10. In this paper, taking example for the diesel cylinder head cover, the low noise design process of parts was expatiated, which MBD(Sentencedict.com), FEM and BEM were combined with topology optimization.

11. The cylinder head is attached to the block with high - tensile steel studs.

12. In this paper, the temperature reduction of cylinder head metal wall and the influence on engine performance are investigated by different thickness of PSZ coating on cylinder head combustion surface.

13. The combustion pressure force in the cylinder head bolts is transferred via reinforced sections in the cylinder block walls direct to the main bearings.

14. The most common cylinder head types are the hemi, wedge, and semi - hemi.

15. The features of cylinder block and cylinder head core assembly vertical casting process are introduced.

16. The engine cylinder head made by vermicular graphite cast iron is not easy to control because of many factors influenced on the production quantity and its optarion limits are very narrow.

16. Sentencedict.com try its best to gather and create good sentences.

17. A north-west gale had given us a good shaking up crossing from Peterhead to Wick resulting in a cracked cylinder head.

18. It is perfectly possible to replace the hot spots in a Land Rover cylinder head.

19. The only effective remedy is to install hardened valve seats or a replacement cylinder head, both expensive options.

20. The question is the charge of gas, exploded in the cylinder head, which is the motive force of every piston-stroke.

21. The features and principles of the double tightening method for cylinder head bolts is introduced to insure the uniform pressure on cylinder gasket during assembling operation.

22. Research has believed that veining in admission and exhaust passage of diesel engine cylinder head may mainly be caused by crack of sand core occurring in high temperature phase change expansion.

23. A numerical simulation is presented for 3 - D filling progress of engine cylinder head casting.

24. The relationship between calcium stearate and sand core as well as casting quality of cylinder head of diesel engine for example is analyzed.

25. Several important tests on torque - angle tightening process of diesel engine cylinder head bolts were introduced.

26. A fuel injection valve (17) is mounted to an upper surface of the cylinder head (20).

27. Based on the analysis of the data obtained, the inverse filter is designed, and the measurement of the cylinder pressure from the cylinder head acceleration by in...

28. In addition, the influence of different idling speeds, different positions of idling air screw and different temperatures of cylinder head on exhuast emissions is also discussed.

29. Through reliability analysis, F 3 is the best proposal operation requirement of current cylinder head.

30. The conclusions are of benefit to the improvement of the diesel engine with integrated cylinder head.